i 16-Port 10/100Mbps Fast Ethernet Switch User’s Guide Version 2.0 P/N: ATC020411SD16 Rev.A This User's Guide contains important informat
6 IDENTIFYING EXTERNAL COMPONENTS This section identifies all the major external components of the switch. Both the front and rear panel is shown, fo
7 Rear Panel Twisted-Pair Ports All ports support the automatic MDI/MDIX crossover detection function which gives true ‘plug and play’ capability wi
8 TECHNICAL SPECIFICATIONS General Standards IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100 Base-TX Fast Ethernet IEEE 802.3x flow control Protocol CS
9 Amer.com Warranty Policy Limited Lifetime Warranty In the event of a defect in quality or workmanship, Amer.com will repair or rep
10 Limits and Expectations There are no express warranties except as listed above. Network products by Amer.com shall not be liable for incidental
ii Amer.com 7259 Bryan Dairy Road, Largo, FL 33777 © Amer.com Corp., 1997-2002 All rights reserved. No part of this publication may be reproduc
iii • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which
iv TABLE OF CONTENTS ABOUT THIS GUIDE ...
1 ABOUT THIS GUIDE Congratulations on your purchase of the 16-port 10/100Mbps Fast Ethernet Switch. This device integrates 100Mbps Fast Ethernet a
2 INTRODUCTION This chapter describes the features of the Switch and some background information about Ethernet/Fast Ethernet switching technology.
3 LAN Switching technology is a marked improvement over the previous generation of network bridges, which were criticized by their higher latencies.
4 Store-and-Forward switching method Integrated address Look-Up Engine, supports 8K absolute MAC addresses Supports 512Kbytes RAM for data buf
5 UNPACKING AND INSTALLATION This chapter provides unpacking and setup information for the Switch. Unpacking Open the shipping carton and carefully u
Komentarze do niniejszej Instrukcji